The test tool of the manufacturer of inspection fixture and clamping mechanism is a special form of resource recovery. Fix the base plate by moving the positioning and clamping device, quickly clamp the part, and then use three coordinate measurement parts for testing. Usually used for platform products, such as floor panels, door panels, fenders, front covers, rear covers, etc. Flexible detection has advantages that special detection tools do not have. With a little adjustment, different products can be measured, and it has the advantages of automatic detection, high precision, low maintenance cost, and short development cycle. In addition, the flexible inspection tool based on the articulated arm measuring machine and the inspection equipment based on the general-purpose robot based on the single-section measurement card specification are supported by the basic bracket. By switching between different pre-implantation programs, the corresponding parts can be measured quickly and easily.

Accurate control of body size is a key technology for automobile factories. Whether it is 2mm engineering or 6sigma management, its essence is inseparable from the data-based detection and monitoring system. By modeling and analyzing the detection data in the manufacturing process, the source of dimensional deviation of the body and parts can be controlled, the stability of manufacturing can be ensured, and the assembly accuracy of the whole vehicle can be improved. However, at present, manual measurement tools are generally used for testing, the measurement efficiency is low, the manual measurement error is large, and the specific value cannot be obtained through the specified measurement. The statistical analysis of system data is difficult, which affects the improvement of vehicle quality.

The manufacturing accuracy of the inspection device of the inspection tool clamping mechanism manufacturer is generally low, and the contradiction with the continuous improvement of the accuracy of the vehicle is becoming increasingly prominent. At present, the manufacturing accuracy of the detection device is still maintained at -0.1~+0.05mm, the manufacturing accuracy of the detection module is 0.1mm, and the manufacturing accuracy of the detection module is 0.15mm. The quality and accuracy requirements of vehicles are getting higher and higher. The assembly accuracy of large interior devices is required to be less than 1mm, the dimensional accuracy of structural injection devices is required to be 0.5mm, and the key matching requirement is 0.3mm.

Inspection fixture clamping mechanism manufacturers improve inspection efficiency and accuracy

On the basis of traditional test tools, combined with the information processing system, an automatic measurement mechanism is added to automatically generate part test reports and data analysis reports, which improves the measurement efficiency and reduces Manual measurement errors are avoided, data processing and analysis errors are avoided, and the accuracy of test reports and measurement efficiency are improved. Automatic statistical analysis and comparison of online processing product inspection data can determine the consistency, stability and consistency of the measurement data size. In the design process, realize the preventive alarm of the production line, avoid unqualified products, batch manufacturing and continuous deterioration of the production line, and minimize the quality loss of testing tools.